TIP for setting transmitter for RC-USB
CAUTION: Do not charging your tx-battery inside transmitter while it connect with RC-USB
CAUTION: Direction of DSC plug is very important.
you must sure that side of white wire of DSC plug is same as this picture.
--------------------------------------------------------------
slide POWER switch to DISP ON (display ON)
for use only LCD display and DSP port.
don't slide to PWR ON, cause of we don't to use RF power.
--------------------------------------------------------------
Function: M-SEL (Model Select)
this function should use before set another function,
for select model that you want to use with RC-USB
--------------------------------------------------------------
Function: M-RES (Model Reset)
TYPE = ALL
press + and - button together, hold on more than 1 second.
--------------------------------------------------------------
Function: RXSYS (Receiver Type/Servo Response Mode)
Servo Response = NORMAL
RX TYPE = FASS-C1
after change setting,
you must turn off transmitter more than 3 second then turn on,
it will complete modulation change.
--------------------------------------------------------------
Function: THMOD (Throttle MODE)
THMOD = FWD50/BRK50
--------------------------------------------------------------
Function: SWTCH
PS1: CH4 / NOR
PS2: CH3 / NOR
PS3: OFF / NOR
TIP for setting FUTABA 3PK/3PKS for RC-USB connect via DSC port
--------------------------------------------------------------
Turn on "DISPLAY" switch for use only LCD display and DSP port.
don't turn on "POWER" switch, cause of we don't to use RF power.
--------------------------------------------------------------
3PK Function: MDL-SEL (Model Select)
3PKS Function: M-SEL (Model Select)
this function should use before set another function,
for select model that you want to use with RC-USB
--------------------------------------------------------------
3PK Function: MDL-RES (Model Reset)
3PKS Function: M-RES (Model Reset)
press + and - button together, hold on more than 1 second.
--------------------------------------------------------------
3PK Function: MOD-MODE (Modulation Mode)
3PKS Function: P-MOD (Modulation Mode)
MODULATION = PPM
press + and - button together, hold on more than 1 second.
after mode change.
you must turn off transmitter more than 3 second then turn on,
it will complete modulation change.
--------------------------------------------------------------
3PKS Function: THMOD (Throttle MODE)
forward side and reverse side ratio
TH-MODE = F50/B50
--------------------------------------------------------------
3PK Function: FUNC-SW
3PKS Function: SWTCH
SW1: OFF / NOR
SW2: CH3 / NOR
SW3: OFF / NOR
Information by 9TURBO | THAILAND